Paver Repair & Re-Leveling in Kenner

Plenty of Kenner homes sit on reclaimed lakefront land that was filled and flattened decades ago. That ground is still settling, and when it shifts, the paver patio or walkway on top of it shifts too. If your hardscape has gone wavy, grown lips between sections, or started holding water after a storm, you don’t need a full tear-out. Pavers can be lifted, the base under them corrected, and the same units reset flat. That’s the whole advantage of pavers over a poured slab, which has to be demolished once it cracks.

Why Kenner Patios Drift Out of Level

Much of Kenner, especially the neighborhoods built out toward Lake Pontchartrain, sits on reclaimed flat lots. Fill soil compacts at different rates, so one corner of a patio can drop while the rest holds steady. Add a high water table and the heavy rain this part of Jefferson Parish gets, and fines wash out from under the pavers and leave voids the surface eventually settles into.

It helps to be clear about what isn’t to blame. Lake Pontchartrain is brackish, not salt water, and the Gulf is over 40 miles south, so the patio isn’t getting eaten by salt air. The real culprits are humidity, downpours, and fill soil that keeps settling under your feet.

How We Reset a Settled Patio

Repair beats replacement almost every time on a paver job. Here’s the order of work on a typical Kenner reset:

• Lift the sunken or raised pavers, keeping them in sequence so the pattern returns exactly the way it started.
• Check the base for washouts and weak spots, then re-grade and recompact it so water drains away from the house.
• Reset the pavers to one true level plane and confirm the slope sheds water correctly.
• Swap out any cracked or chipped pavers with matching units so the repair disappears into the field.
• Refill the joints with polymeric sand to lock the surface and hold back weeds.

Regrading a Base That Failed

When a wide stretch of patio has dropped, the sub-base under it has usually given out. We pull that section, strip the bad material, and rebuild with compacted base set to a corrected grade. Spend the effort on the base now and the surface stays put for years instead of sinking again next rainy season.

Joint Sand Repair

If the pavers are still flat but the sand between them has washed away or sprouted weeds, a re-sand fixes it on its own. We clear the old joints, pack in fresh polymeric sand, and set it so the whole surface ties back together and drains the way it was built to.

Let’s Get Your Kenner Hardscape Flat

Wobbly pavers, raised edges you keep tripping on, or puddles that linger after rain are all signs of a base that needs attention, not a reason to start over. We’ll take a look, tell you straight whether it’s a spot reset, a re-sand, or a base repair, and give you a clear quote. Get in touch and we’ll get your patio level again.